Alocasia × mortfontanensis (Also known as ' Alocasia × amazonica 'Polly' ' - scroll down to 'Origins' to find out more about its complicated past!).
For queries or questions, comment in the section below or send us a message via this link!
Alocasia are best situated in a bright location that boasts overhead lighting, but if you can't provide this, within two metres of a window will still do the job. Those situated in a shady location must have their leaves rinsed from time to time to improve the light-capturing efficiency. Never allow it to sit in strong sunlight for extended periods, as too much light will result in a pale, washed-out appearance with possible brown patches forming on the leaves.
The amount of light and current season of the year will directly govern the frequencies of waters per month. Specimens placed in darker areas must be kept on the drier side to life, whereas brighter locations will require more soil moisture to lubricate photosynthesis.
Allow the top third of the soil dry out in between waters during the active growth period, reducing this further in the autumn and winter. Due to the sensitivity of their root systems, never apply cold water as it may weaken its health and well-being over time. For those that use tap water (instead of rainwater or fresh bottled water), allow it to stand for at least 24hrs to eliminate the high levels of chloride and fluoride found from the tap. Under-watering symptoms include wilting, little to no growth and greying leaves - these issues are commonly down to too much light/heat, or forgetfulness. Alternatively, over-watering symptoms include rapidly yellowing lower leaves, wilting (root rot), brown spots on leaves, and a rotten stem. Specimens that are located in a darker area are more likely to adopt root rot as the soil may not dry out sufficiently in between waters. Remember - under-watering is far better than over-doing it, due to the species' corm that can retain moisture in times of short-lived droughts.
Average room humidity will be accepted by an African Mask Plant, but remember to introduce a pebble tray while the heaters are operating to counteract dry air. A quick monthly hose down in the shower will hydrate the leaves, eliminate dust particles and help reduce numbers of pests, most notably spider mites.
Twice a month in the growing period, and monthly during the autumn and winter to replicate its dormancy period. Either use a 'houseplant' labelled fertiliser, or a general plant feed at half strength. Never apply an RTU (Ready to Use) product without a quick drink of water beforehand, due to the heightened risk of chemical root burn. Regular supplements are essential for reliable growth during the spring and summer months, as stunted growth could be a cause of irregular feeds.
Regular waters and fertilisations are essential. Periods of droughts will quickly slip the Alocasia back into its dormancy period, thus causing stunted growth and a bewildered plant owner. If it hasn't repotted in a while, there may be too many roots and not enough soil to retain moisture, thus leaving the compost to dry out quicker. Click on this link to learn more about a transplant.
Pests could arise at any time, with infestations starting from the original nursery or via contamination in your home. Spider mites and mealybugs to tend to be the usual inhabitants, with the first being minute and almost transparent, roaming the leaves in search of chlorophyll and a site to hide its eggs. The latter, however, will stand out much more, with white cottony webs developing across the foliage and stems. Thoroughly check the plant's cubbyholes before giving it the all-clear, or click on the appropriate links to learn more about eradicating these issues!
The rapid yellowing of older leaves and a wobbly plant are a clear sign of over-watering, usually caused by too little light. Although Alocasia can do well in darker locations, the frequency of irrigations must be reduced to counteract the chance of root rot. People don't realise that a plant's root system needs access to oxygen too; when soil is watered, the air will travel upwards and out of the potting mix. A lack of accessible oxygen for the roots will cause them to subsequently breakdown over the oncoming days. Click on this link to learn more about root rot and how to address it, and always feel the pot's weight for confirmation (heaviness = good soil moisture, & vice versa).
Too low humidity can cause browning tips with yellow halos on juvenile leaves. Although this won't kill your specimen, you may want to increase the local moisture to prevent the new growth from adopting these symptoms. Mist or rinse the foliage from time to time and create a humidity tray while the heaters are active to create a stable environment. Browning leaf tips are an inevitable part of a leaf's maturity though, so never be too disheartened if your specimen is showing signs of this!
Clean the leaves regularly. Although this isn't too much of an issue, a build-up of dust particles can clog up the plant's pores, causing lowered light capturing-efficiency. Rinse the topsides of the leaves down once a month to keep levels down and improve growing conditions.
Mould or mushrooms developing on the soil means two things - too little light and over-watering. Despite the harmlessness, it'll prove unsightly to most gardeners and is therefore removed once known. To remove, replace the top two inches of the soil for a fresh batch of 'houseplant' compost. Either increase the amount of light received (no direct sunlight for the first few weeks to prevent environmental shock) or decrease the frequency of waters slightly. If the mould is accompanied by yellowing lower leaves, you may also have a case of root rot.
There are several species of Leaf-Spot Disease, (Graphiola, Botrytis, Anthracnose & Cercospora) and all of them operate in the same way. Fungi spores will land on the leaf's surface and will slowly develop along with the plant. Unfortunately, as there aren't any products that'll address the issue head-on, you can only remove the affected areas and regularly wash the leaves to limit the spread. In some cases, however, the small yellow spots are caused by inconsistent soil moisture and is not the direct product of a disease. Think about your own cultivation habits and make a decision on what to do. If you're still unsure afterwards, don't hesitate to send us an email or direct message via our Instagram page for our expert advice!
Other yellowing leaves - it isn't easy to accurately pinpoint why this is happening as it could be due to many different reasons. If the lower leaves are yellowing in quick concession, it could be over-watering. Do not allow the soil to become soggy or waterlogged; failure to do so will cause root rot and possible death. For severe cases, take the plant out of rot pot to examine for root rot - a transplant may have to be performed. The second reason why its leaves are yellowing could be due to either too much sunlight or not enough water. As mentioned above, under-watering can cause an African Mask Plant to slip into its dormancy period. Still, persistent droughts with direct sunlight will cause further damage in the likes of yellowing leaves, stunted growth and wilting.
There have been many arguments over the similarities between the 'Poly' and 'Amazonica' variants. The only visual difference between the two us that the latter is slightly bigger. Some lean towards the idea that they are the same plant and others with the view that they're different due to the chromosomes. If 'Alocasia polly' is searched on the web, you'll be surprised to find that the original name for this hybrid was the A. poly with only one 'L'. This refers to their polypoid nature, although this was later proved wrong, thus strengthening the idea that the A. amazonica and A. poly could indeed be the same plants.
The arguments over the taxonomy of the two don't end there; the A. amazonica isn't actually from the topics of Brazil; neither is it the actual name of the plant. The term 'Amazonica' can be traced back to the 1950s in Miami when a man named Salvador Mauro created the hybrid in his garden centre named 'Amazon Nurseries'. There have been many arguments over the correct name of the species in question due to the many hybridised versions that have been created; it was only the potentially incorrect 'Amazonica' that remains today. Although the adopted name is traced back to the 50s, it was in fact, the Chantrier brothers who crossed an A. longiloba (previously called A. lowii) and an A. sanderiana to create the hybrid that we know and love today. The name? Alocasia × mortfontanensis, named after the French village, Mortefontaine where the brothers were based.
Unfortunately, it doesn't entirely end there, either! Some botanists still argue that the two are different species, as the latter sports slightly bigger leaves. As well as this, the original name of the A. sanderiana could be called an A. watsoniana, a name that is now considered a synonym and not an individual hybrid. Because of all this intertwined commotion of different names and scientific taxonomy, it's become a tricky situation to resolve fully. Who knows what's actually happened over the 130 years, but one thing for sure, you wouldn't imagine horticulture being this controversial!
10° - 30°C (50° - 86°F)
H1b (Hardiness Zone 12) - can be grown outdoors during the summer in a sheltered location with temperatures above 12℃ (54℉), but is fine to remain indoors, too. If you decide to bring this plant outdoors, don't allow it to endure any direct sunlight as it may result in sun-scorch and dehydration. Regularly keep an eye out for pests, especially when re-introducing it back indoors.
Over 0.7m in height and 0.5m in width once the specimen reaches maturity. The ultimate height will take between 5 - 10 years to achieve, with several new leaves grown per year.
Remove yellow or dying leaves, and plant debris to encourage better-growing conditions. While pruning, always use clean utensils or shears to reduce the chance of bacterial and fungal diseases. Never cut through yellowed tissue as this may cause further damage in the likes of diseases or bacterial infections. Remember to make clean incisions as too-damaged wounds may shock the plant, causing weakened growth and a decline in health.
Via Seed or Basal Offset Division (attached to the lower stem).
Basal Offset Division (Easy to Moderate) - Your plant will produce several offsets that can be separated once they have a sufficient root system, and surpass 25cm in height. If possible, water the soil 24hrs before the main event to reduce the risk of transplant shock, when its dry root systems are over-fingered. Take the plant out of its pot and place your fingers close to the nodal junction - soil may have to be removed for better access. Push the chosen offset downwards until you hear a snap. Separate the foliage and its root system away from the mother plant, mentally noting the high risk of damage. Transplant in the appropriate sized pot with a fresh batch of houseplant soil. Maintain evenly moist soil and situate it in a bright, indirect location away from any direct sunlight. After eight weeks, treat it like a normal specimen following the care tips above! These tips can be replicated onto 'Cormlet'/'Cormel' division (pictured below), too!
As African Mask Plants are part of the Araceæ family, their inflorescences aren't showy. Much like a Peace Lily's flower, their flowers consist of a white or green spathe (the spoon-like shell) with the spadix being the site of pollination. Blooms can last up to three days and are usually visible during late spring or early summer around 30cm+ from the soil line.
Repot biannually in spring using a 'houseplant' labelled potting mix and the next sized pot with adequate drainage. African Mask Plants are far better being potbound for several years due to the heightened risk of root rot and repotting-issues (like transplant shock, which will result in yellowed leaves and wilting), so only repot if you feel it's wholly necessary.
Hydrate the plant 24hrs before the tinkering with the roots to prevent the risk of transplant shock. For those situated in a darker location, introduce an extra amount of perlite and grit into the new soil to downplay over-watering risks. Click on this link for a detailed step-by-step guide on transplantation, or via this link to learn about repotting with root rot.
Keep an eye out for mealybugs, spider mites, thrips & fungus gnats that'll locate themselves in the cubbyholes and undersides of the leaves. Common diseases associated with African Mask Plants are root rot, leaf-spot disease, botrytis, rust, powdery mildew & southern blight - click here to learn more about these issues.
This plant is classified as poisonous due to varying concentrations of calcium oxalate crystals found around the plant's body. If parts of the plants are eaten, vomiting, nausea and a loss of appetite could occur. Consumption of large quantities must be dealt with quickly; acquire medical assistance for further information.
IKEA, Blue Diamond & Online Stores.
If you need further advice with indoor gardening, never hesitate to send us a message or leave a comment in the section below. This could be about your own specific plant, transplantation into a bigger pot, pests or diseases, terrarium ideas, & more!